beautypg.com

Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual

Page 264

background image

4-69

FIC-2E&M/FIC-4E&M, the 2-/4-port voice E&M analog trunk interface module, provides and transmits
over data communications networks voice signals for 2/4 E&M analog trunks.

Interface attributes

The following table describes the interface attributes of the FIC-2FXS/FIC-2FXO/FIC-2E&M and the
FIC-4FXS/FIC-4FXO/FIC-4E&M.

Table 4-56 Interface attributes of the FIC-2FXS/FIC-2FXO/FIC-2E&M and the
FIC-4FXS/FIC-4FXO/FIC-4E&M

Attribute

Description

Connector

RJ-45

Number of connectors

z

2 (FIC-2FXS/FIC-2FXO/FIC-2E&M)

z

4 (FIC-4FXS/FIC-4FXO/FIC-4E&M)

Cable

z

Telephone cable with ferrite core

z

E&M trunk cable (only for E&M modules, made on site)

Interface standard

z

ITU Q.512-compliant subscriber circuit interface (FIC-2FXS/FIC-4FXS)

z

ITU Q.552-compliant loop trunk interface (FIC-2FXO/FIC-4FXO)

z

G.712-compliant E&M trunk interface (FIC-2E&M/FIC-4E&M), E&M
interface (supporting Bell type I, II, III, and V, using both two-wire and
four-wire implementations)

z

ITU K.20-compliant overcurrent protection

Dial-up mode

Dual-tone multifrequency (DTMF), compliant with GB3378
(Pulse dial is not available.)

Bandwidth

300 Hz to 3400 Hz

Interface LEDs

The following figure illustrates the FIC-2FXS panel:

Figure 4-88 FIC-2FXS panel

The following figure illustrates the FIC-2FXO panel:

Figure 4-89 FIC-2FXO panel

The following figure illustrates the FIC-2E&M panel:

This manual is related to the following products: