Gasboy SiteOmat Maintenance Manual User Manual

Page 64

SiteOmat Setup and Maintenance Manual – MDE 4817G

SECTION 4

SETUP WIZARD

4-1. GENERAL

The Setup Wizard helps the technician to set up the station, guiding the user through the process

and initializing most of the system's setup parameters automatically. Once the Wizard is finished,

most standard stations are ready for fueling and no additional settings are required.

The wizard also allows selection of predefined templates for fully configuring the system according

to stations with similar characteristics. If a predefined template is selected, the wizard consists of

pages that contain specific station data only.

After the Wizard is finished, the Main Setup screen is displayed, enabling the user to complete the

process, or to change to the Advanced Mode in order to define more complex forecourt

configurations.

Rerunning of the wizard is allowed; however, the existing setup data is overwritten (fuelling data

such as transactions are not deleted). In such cases, the user is provided with a proper warning.

The Cancel button in each screen enables the user to cancel the process and return to the main
Setup

window. In this case, no data is saved, and no changes are made to the system. The user is

alerted that all changes are lost if the process is cancelled in the middle.

In cases where the configuration is done without the wizard, the logic of the setup procedure should

be from top to bottom. That is, first define the physical configuration: Station Parameters, Alarms

and Communication (FCC) channels, etc. Once these parameters have been set, define the Setup

parameters. This Setup includes first the buses or communication channels, then the definition of

peripherals such as printers and tag readers. Setting the system in this order ensures the definition of

all the existing building blocks for each component.

NOTE

In cases where the Wizard is rerun after settings

were changed from SiteOmat Setup screens, the

Wizard may not reflect the changes made (i.e.

settings not supported by the Wizard).