Gasboy SiteOmat Maintenance Manual - Manual (Page 142)

138
SiteOmat Setup and Maintenance Manual – MDE 4817G
7-7. TANK LEVEL GAUGE – TLG
7-7.1. General
Tank Level Gauge System (TLG) screen enables technicians to define external devices that read
fuel tank information using probes.
To open the TLG Dialog Box (see Figure 7-8), select the TLG tab in the Setup screen.
Figure 7-8. TLG Dialog Box
Before entering any new TLG in the system, define a bus for the TLG in the Buses screen (refer to
paragraph 7-3). Enter the Name of the TLG and define the Bus.
Next, select the Model by clicking in the drop-down list. Four models are currently supported:
• Veeder-Root TLS 350 and 450 (For all TLG systems using VR TLS protocol)
• OPW
• Hectronic
• Start Italiana
Leak Detection:
Select this checkbox to use the Leak Detection mechanism in an external TLG.
Password:
The TLG password used for communication between SiteOmat and the TLG.
7-7.2. Probes
Once the TLG is defined, users are required to define the TLG physical probes. Click on the Probes
button. The Probes dialog box appears (see Figure 7-9).
Enter an address for each probe. Each probe must have an address that should match the address
defined in the TLG.