Gasboy SiteOmat Maintenance Manual - Manual (Page 160)

156
SiteOmat Setup and Maintenance Manual – MDE 4817G
Figure 7-25. Pump Server Settings Screen
First, in the General section select the pump Type (protocol) that is to be linked to this Pump
Server. Next, define the Authorization TimeOut for the pump, in seconds. This parameter sets the
time for stopping the pump, when the pump is authorized but there is no fuel flow.
It is highly recommended not to define the Logging section parameters. Only Gasboy certified
technicians should enable this feature. Logging enables data transfer between the pump and the
pump server.
To enable Logging, click on the appropriate checkbox, as described in Table 7-3:
Table 7-3 Logging Section Parameters
Parameter Description
Pump Communication:
Enables generation of Pump- Pump Server communication
logs.
Comm (FCC)
Communication:
Enables generation of Controller- Pump Server communication
logs. The connection Port must be defined.
Application:
Enables application logs generation on the Pump Server. The
connection Port must be defined.
By setting the ports the logs could be monitored with a Telnet terminal without enabling the logs.