Gasboy SiteOmat Maintenance Manual - Manual (Page 106)

102 SiteOmat Setup and Maintenance Manual – MDE 4817G
5-5. REGISTRATION
The registration screen is intended for registration of the Wireless Programmer system which is part
of the FuelPoint PLUS solution (see Figure 5-7).
The installer establishes appropriate communication between the Programmer and the SiteOmat to
allow flow of data between the vehicles' installed units and the FCC.
NOTE
If running an FHO, registration should be performed
in the FHO. It is highly recommended to run
FuelPoint PLUS with Fleet Head Office.
Setting up of the home based systems requires the installer to conduct three phases as follows:
1. Installing the Wireless Programmer Tunnel S/W
2. Setting up communication between the Programmer and the FCC
3. Programming and configuring the vehicle units
For more details see Fuel Point PLUS Installation and Configuration Manual for home base P/N
MDE-4851.
Figure 5-7. Registration Screen