Gasboy SiteOmat Maintenance Manual - Manual (Page 184)

180
SiteOmat Setup and Maintenance Manual – MDE 4817G
8-2. SYSTEM COMMANDS
The SiteOmat BOS screens include several commands for controlling and operating the BOS and
the FCC. This section describes the various administrative commands invoked from the SiteOmat
Sys Command screen (see Table 8-3).
To enter the Sys Command screen (see Figure 8-3), click on the Admin button on the left-hand side
and select the Sys Command tab.
Table 8-3. Sys Commands
Command Description
Start
Starts the FCC operation.
Click on the Start button to start FCC that was in stop state. Note that if
during the reload operation power failed, the FCC may be in stop state after
power is back, click Start to start communication.
Stop
Stops the operation of the FCC and all communication to peripheral devices.
After using this command, the FCC does not start until either the Start of the
Reload commands are invoked, even if the FCC computer is rebooted, it
remains in stopped state.
Reload
Performs the functions Stop followed by Start and Reload.
Sys Init
Saves station setup changes, for instance:
• Installation of a new station, and definition of equipment setup
• Setup modification (e.g. defining a new pump or nozzle)
• Recovery operation
The Reload command must also be invoked subsequently.
Log Settings
Sets log policy (see paragraph 8-2.1)
Reset Pumps
Resets the states of all pumps.
Reset Pump
Resets the state of a specific pump.
Sync FCC
This command must be invoked after the SysInit in the following cases:
• An upgrade from SiteOmat V5
• A recovery operation
The Reload command must be executed after the procedure.
End of day
Activates the EOD process (Collects both tank levels and dispensers
meters.)