AMETEK Lx Series II Programming Manual - Manual (Page 87)

Programming Manual Lx \ Ls Series II
83
Command Syntax [SOURce:]LIST:SHAPe{,}
Parameters SINusoid|SQUare|CSINusoid|
Examples LIST:SHAP
Query Syntax [SOURce:]LIST:SHAP?
Returned Parameters
Related Commands LIST:SHAP:POIN? LIST:COUN LIST:DWEL LIST:STEP LIST:VOLT
LIST:SHAPe:POINts?
This query returns the number of points specified in LIST:SHAP. Note that it returns only the total
number of points, not the point values.
Query Syntax [SOURce:]LIST:SHAPe:POINts?
Returned Parameters
Example LIST:SHAP:POIN?
Related Commands LIST:SHAP
LIST:STEP
This command specifies how the list sequencing responds to triggers.
ONCE causes the list to advance only one point after each trigger. Triggers that arrive during a
dwell delay are ignored.
AUTO causes the entire list to be output sequentially after the starting trigger, paced by its dwell
delays. As each dwell delay elapses, the next point is immediately output.
Command Syntax [SOURce:]LIST:STEP
Parameters ONCE | AUTO
*RST Value AUTO
Examples LIST:STEP ONCE
Query Syntax [SOURce:]LIST:STEP?
Returned Parameters
Related Commands
LIST:COUN LIST:DWEL
LIST:TTLTrg
This command sets the sequence of Trigger Out list points. Each point which is set ON will cause
a pulse to be output at Trigger Out when that list step is reached. Those entries which are set
OFF will not generate Trigger Out pulses. The order in which the list points are given determines
the sequence in which Trigger Out pulses will be output when a list transient is triggered.
Changing list data while a subsystem is in list mode generates an implied ABORt.
Command Syntax [SOURce:]LIST:TTLTrg{,}
Parameters 0 | 1 | OFF | ON
Examples LIST:TTLT 1,0,1 LIST:TTLT ON,OFF,ON
Query Syntax LIST:TTLT?
Returned Parameters 0 | 1
Related Commands LIST:TTLT:POIN? LIST:COUN LIST:DWEL LIST:STEP
OUTP:TTLT:STAT OUTP:TTLT:SOUR
LIST:TTLTrg:POINts?
This query returns the number of points specified in LIST:TTLT. Note that it returns only the total
number of points, not the point values.