AMETEK Lx Series II Programming Manual - Manual (Page 192)

Programming Manual Lx \ Ls Series II
188
8.4 RTCA/DO-160D (-160)
The following are the remote commands available for the -160 test option. The ABORt command
will terminate the test in progress at any time. See the Lx / Ls Series II User Manual (P/N 7004-
980) for more details about the implementation of each 160 test step.
Note: Only revision C and D are implemented in firmware and as such have specific SCPI
commands assiated with it. The revision E implementation (see section 8.5) is
implemented through the LxGui Windows program only and there are no SCPI commands
for it. Refer to the Avionics Software Manual (CI P/N 4994-971) for more information.
8.4.1 Command Tree
DO160
:NORMal
:VOLT_FREQ
:MINinum
:MAXimum
:VOLTage
UNBalance
:WAVeform :DISTortion
:VOLTage
:MODulation
:INTerrupt
:SURGe
:FREQency
:MODulation
:TRANSient
:VARiation
:EMERgency
:VOLT_FREQ
:MINimum
:MAXimum
:VOLTage
:UNBalance
:ABNormal stage
:VOLTage
:MINimum
:MAXimum
:UNDer
:OVER
:UNBalance
:FREQuency
:TRANsient
:STANdard
:GROup