AMETEK Lx Series II Programming Manual User Manual
Page 110
Programming Manual
Lx \ Ls Series II
106
SYSTem:COMMunicate:GPIB:ADDRess
This command will set the GPIB address.
Command Syntax
SYSTem:COMMunicate:GPIB:ADDRess
Parameters
0 to 31
Example
SYST:COMM:GPIB:ADDR 2
Returned Parameters
SYSTem:COMMunicate:LAN:ADDRess
This command will set the LAN IP address. The query format returns the IP address set. To query
the actual IP address used by the LAN interface (in case the IP address is not static but assigned
by a DHCP server), the NCON parameter (Network Connection Setting) must be added to the
query. The default value is 0.0.0.0.
Command Syntax
SYSTem:COMMunicate:LAN:ADDRess
Parameters
ddd.ddd.ddd.ddd
Example
SYST:COMM:LAN:ADDR 255.255.167.2
Query Syntax
SYST:COMM:LAN:ADDR?
SYST:COMM:LAN:ADDR? NCON
Returned Parameters
SYSTem:COMMunicate:LAN:APPLy
This command will apply the changes in LAN setting. The controller will go to reset condition and
the new LAN setting will take effect.
Command Syntax
SYSTem:COMMunicate:LAN:APPLy
Parameters
none
Example
SYST:COMM:LAN:APPL
Query Syntax
no query for this command
Returned Parameters
none
SYSTem:COMMunicate:LAN:DEFault
This command will apply the changes in LAN setting to the default setting. The controller will go to
reset condition and the default LAN setting will take effect. Both IP address and Gate way address
are set to zero. The Host name is cleared. The password is reset to “admin”The unit is set to
DHCP or Auto IP.
Command Syntax
SYSTem:COMMunicate:LAN:DEFault
Parameters
none
Example
SYST:COMM:LAN:DEF
Query Syntax
no query for this command
Returned Parameters
none
SYSTem:COMMunicate:LAN:DESCription
This command will set the user description. The description is limited to 24 characters