AMETEK Lx Series II Programming Manual - Manual (Page 219)

Programming Manual Lx \ Ls Series II
215
8.7.5 MS704 Emergency State Commands
Emergency state tests can be started by sending one of the MS704:EMER commands. Available
emergency state commands are listed below.
MS704:EMERgency:LIMit[:ALL]
This command will run all emergency state operation mode tests.
Command Syntax MS704:EMERgency:LIMit[:ALL]
Parameters none
Examples MS704:EMER:LIM
Query Syntax none
MS704:EMERgency:LIMit:NOMinal
This command will run the emergency state nominal operation mode tests.
Command Syntax MS704:EMERgency:LIMit:NOMinal
Parameters none
Examples MS704:EMER:LIM:NOM
Query Syntax none
MS704:EMERgency:LIMit:LOW
This command will run the emergency state low operation mode tests.
Command Syntax MS704:EMERgency:LIMit:LOW
Parameters none
Examples MS704:EMER:LIM:LOW
Query Syntax none
MS704:EMERgency:LIMit:HIGH
This command will run the emergency state high operation mode tests.
Command Syntax MS704:EMERgency:LIMit:HIGH
Parameters none
Examples MS704:EMER:LIM:HIGH
Query Syntax none