AMETEK Lx Series II Programming Manual - Manual (Page 204)

Programming Manual Lx \ Ls Series II
200
MIL704:TRANsient:FREQuency[:LOW]
This command will set the low frequency level for the transient state operation.
Command Syntax MIL704:TRANseint:FREQuency[:LOW]
Parameters none
Examples MIL704:TRAN:FREQ
Query Syntax none
MIL704:TRANsient: FREQuency:HIGH
This command will set the high frequency level for the transient state operation.
Command Syntax MIL704:TRANseint:FREQuency:HIGH
Parameters none
Examples MIL704:TRAN:FREQ:HIGH
Query Syntax none
8.6.5 MIL704 Abnormal State Commands
MIL704:ABNormal:VOLTage[:UNDer]
This command will set the low voltage level for the abnormal state operation.
Command Syntax MIL704:ABNormal:VOLTage[:UNDer]
Parameters none
Examples MIL704:ABN:VOLT
Query Syntax none
MIL704:ABNormal:VOLTage:OVER
This command will set the high voltage level for the abnormal state operation.
Command Syntax MIL704:ABNormal:VOLTage:OVER]
Parameters none
Examples MIL704:ABN:VOLT:OVER
Query Syntax none
MIL704:ABNormal:FREQuency[:UNDer]
This command will set the low frequency level for the abnormal state operation.
Command Syntax MIL704:ABNormal:FREQuency[:UNDer]
Parameters none
Examples MIL704:ABN:FREQ
Query Syntax none