AMETEK Lx Series II Programming Manual - Manual (Page 202)

Programming Manual Lx \ Ls Series II
198
8.6.3 MIL704 Steady State Commands
MIL704:SSTate:VOLTage
This command will set the voltage level for the steady state operation.
Command Syntax MIL704:SSTate:VOLTage[:LEVel]
Parameters none
Examples MIL704:SST:VOLT
Query Syntax none
MIL704:SSTate:MODulation
This command will set the voltage modulation level for the steady state operation.
Command Syntax MIL704:SSTate:MODulation
Parameters none
Examples MIL704:SST:MOD
Query Syntax none
MIL704:SSTate:UNBalance
This command will set the voltage unbalance for the steady state operation. This command is only
relavent when in 3 phase mode.
Command Syntax MIL704:SSTate:UNBalance
Parameters none
Examples MIL704:SST:UNB
Query Syntax none
MIL704:SSTate:PHASe[:UNBalance]
This command will set the phase angle unbalance for the steady state operation. This command
is only relavent when in 3 phase mode.
Command Syntax MIL704:SSTate:PHASe[:UNBalance]
Parameters none
Examples MIL704:SST:PHAS
Query Syntax none