AMETEK Lx Series II Programming Manual - Manual (Page 74)

Programming Manual Lx \ Ls Series II
70
Command Syntax SENSe:SWEep:OFFSet:POINts
Parameters 4096 through 2E9 | MINimum | MAXimum
*RST Value 0
Examples SENS:SWE:OFFS:POIN -2047
Query Syntax SENSe:SWEep:OFFSet:POINts?
Returned Parameters
Related Commands SENS:SWE:TINT MEAS:ARR
SENSe:SWEep:TINTerval
This command defines the time period between samples. The sample period can be programmed
from 10.42 to 104.2 microseconds in 10 microsecond increments in single-phase mode and from
31.25 to 312.5 microseconds in three-phase mode.
All the MEASure commands use the ACQuire trigger sequence implicitly.
Command Syntax SENSe:SWEep:TINTerval
Parameters 10.42 through 104.2 (microseconds)
*RST Value 10.42 µs or 31.25 µs
Examples SENS:SWE:TINT 100
Query Syntax SENSe:SWEep:TINTerval?
Returned Parameters
Related Commands SENS:SWE:OFFS:POIN MEAS:ARR