AMETEK Lx Series II Programming Manual User Manual
Page 111

Programming Manual
Lx \ Ls Series II
107
Command Syntax
SYSTem:COMMunicate:LAN:DESCription
Parameters
Example
SYST:COMM:LAN:DESC “EVAL UNIT”
Query Syntax
SYST:COMM:LAN:DESC?
Returned Parameters
SYSTem:COMMunicate:LAN:GWADdress
This command will set the LAN Gateway address. The query format returns the Gateway address
set. To query the actual gateway address used by the LAN interface (in case the IP address is not
static but assigned by a DHCP server), the NCON parameter (Network Connection Setting) must
be added to the query. The default value is 0.0.0.0.
Command Syntax
SYSTem:COMMunicate:LAN:GWADddress
Parameters
ddd.ddd.ddd.ddd
Example
SYST:COMM:LAN:GWAD 255.255.255.0
Query Syntax
SYST:COMM:LAN:GWAD?
SYST:COMM:LAN:GWAD? NCON
Returned Parameters
SYSTem:COMMunicate:LAN:HBITs
This command will set the number of host address bits. The query format returns the number of
bits set. To query the actual number of bits used by the LAN interface (in case the IP address is
not static but assigned by a DHCP server), the NCON parameter (Network Connection Setting)
must be added to the query. The default value is 8.
Command Syntax
SYSTem:COMMunicate:LAN:HBITs
Parameters
8 to 32
Example
SYST:COMM:LAN:HBIT 8
Query Syntax
SYST:COMM:LAN: HBIT?
SYST:COMM:LAN: HBIT? NCON
Returned Parameters
SYSTem:COMMunicate:LAN:PASSword
This command will set the user password. The password is used to access to LAN configuration
screen from the Web page. The d
efault password is “admin”. The description is limited to 8
characters.
Command Syntax
SYSTem:COMMunicate:LAN:PASSword
Parameters
Example
SYST:COMM:LAN:PASS “admin”
Query Syntax
SYST:COMM:LAN:PASS?
Returned Parameters
SYSTem:COMMunicate:LAN:PORT
This command will set the socket port number. The query format returns the port number set. The
default value is 5025.
Command Syntax
SYSTem:COMMunicate:LAN:PORT
Parameters
0- 65535
Example
SYST:COMM:LAN:PORT 5025
Query Syntax
SYST:COMM:LAN: PORT?
Returned Parameters
SYSTem:COMMunicate:SERial:BAUD
This command will set the SERial communication baud rate.