System commands – AMETEK Lx Series II Programming Manual User Manual
Page 109

Programming Manual
Lx \ Ls Series II
105
4.24 System Commands
The system commands control the system-level functions of the Lx\Ls Series.
Subsystem Syntax
SYSTem
:COMMunicate
:GPIB
:ADDRess
Set GPIB address
:LAN
:ADDRess
Set LAN IP address
:APPLy
Apply the change in setting
:DEFault
Set LAN to a default known setting
:DESCription
Set user description
:DNSaddress
Set LAN DNS addres
:GWADdress
Set LAN Gateway
:HBITs
Set LAN Host bits
:PASSword
Set LAN password
:PORT
Set LAN socket port address
:SERial
:BAUD
Set the baud rate
:PARity
Set the parity type
:BITS
Set number of bits
:SBITs
Set number of stop bits
:CONFiguration
Queries the source configuration data
:NOUTputs
Selects the number of output phases
:ETIMe
Returns accumulated on time
:ERRor?
Returns the error number and error string
:LANGuage
Sets the programming language
:LOCal
Go to local mode (RS-232 only)
:REMote
Go to remote mode (RS-232 only)
:RWLock
Local Lock out (front panel LOCAL button, RS-232 only)
:TEMPerature?
Returns temperature inside unit.
:VERSion?
Returns the SCPI version number