AMETEK Lx Series II Programming Manual - Manual (Page 34)

Programming Manual Lx \ Ls Series II
30
The following fields are available in the LANetwork menu:
Menu Values Description
LANetwork LAN If the –LAN option is installed; pressing Enter while
the cursor is on the LANetwork entry provides
access to the LAN interface setting screens listed
below.
1
IP Address Displays the IP address setting. This value can be
changed by pressing the SET key and entering a
new value from the keypad or using the Voltage
and Frequency shuttles. Use the numeric data pad
or the voltage shuttle to enter each field. To move
between the four fields, use the decimal point key
on the keypad or the Frequency shuttle.
To set a fixed IP address, press SET and enter the
desired IP address. To set the unit to DHCP mode,
press SET and enter all zeros (0.0.0.0) as the IP
address and cycle power two times. The obtained
IP address will be displayed after the second power
on. For the DHCP setting to work however, the unit
MUST be connected to a network with a DHCP
server.
Any change to this value will NOT take effect until
after power on the unit has been cycled.
When changing mode from static IP to DHCP, it is
necessary to cycle power on the unit twice, once to
change mode and again to obtain and display a
new IP address from the network.
MAC Address Displays the network Media Acces Control address.
This value is fixed and cannot be changed. The
same MAC is normally printed on the model serial
tag. The MAC address is shown as six hexadecimal
numbers separated by a colon, e.g.
00:20:4A:9A:02:FD. Note that the leading „0‟ is
never visible due to the maximum number of LCD
characters per line.
Note: If the MAC Address displayed is corrupted or
does not match the serial tag, there may have been a
problem retrieving the LAN port settings.This can
happen if a static IP was set that conflicts with
another device on the network. To recover, turn on
power to the unit while holding down the SET key.
This will allow the unit to boot without attempting to
collect the IP settings. You can then set the required
IP values. [See IP Address above].
GWAddress Gateway address setting. A default gateway is a
node (a router) on a computer network that serves
as an access point to another network.
1
This feature requires firmware revision 1.40 or higher. If you upgraded from a lower firmware revision, the LAN configuration has
to be enabled to display this menu. Contact customer service for information on enabled this screen.