AMETEK Lx Series II Programming Manual - Manual (Page 185)

Programming Manual Lx \ Ls Series II
181
SRQ 1 SRQ 1 Reported Message Cause
90 26 RNG RANGE ERROR RNG value greater than highest range
90 27 AMP RANGE ERROR AMP value greater than RNG value
90 28 FRQ RANGE ERROR FRQ value is less than 45 or greater than 1000
Hz (Ls) or 5000 Hz (Ls-HF)
93 29 PHZ RANGE ERROR PHZ value greater than ±999.0
94 30 CRL RANGE ERROR CRL value greater than maximum value
95 31 RMPA RANGE ERROR DLY, STP or VAL values wrong
96 32 SYNTAX ERROR Wrong string syntax
97 33 BUS LOCAL ERROR Remote message sent while in local mode
98 34 EXT SYNC ERROR No external sync input or signal not between
min and max frequency
99 35 CPU MEMORY FAULT CPU failed power-on self-test
100 36 DMA OVERFLOW ERROR Remote message greater than 256 bytes
63 63 The response after SRQ2 is included in a setup
string and the execution of the string or
measurement is completed.
40 40 STA OK No Error
Table 8-6: APE Status Byte Error Codes