beautypg.com

AMETEK Lx Series II Programming Manual User Manual

Page 194

background image

Programming Manual

Lx \ Ls Series II

190

DO160:NORMal:VOLTage:INTerrupt

This command will cause output voltage interruption. There are 15 different levels of interruption.
Refer to Figure 8-6 in the User Manual for characteristics of each level. Test numbers 16 and 17
for all equipment that does not incorporate digital circuit. Test numbers 21 to 26 correspond to
Standard I through VI for EUROCAE and RTCA2. See Figure 8-7 in User manual.

Command Syntax

DO160:NORMal:VOLTage:INTerrupt

Parameters

Examples

DO160:NORM:VOLT:INT 4

Query Syntax

DO160:NORM:VOLT:INT?

Returned Parameters

DO160:NORMal:VOLTage:SURGe

This command will generate the voltage levels required to generate a normal voltage source.
Refer to Section 8.1.4.1, under the heading titled

VOLTAGE SURGE,

for details.

Command Syntax

DO160:NORMal:VOLTage:SURGe

Parameters

none

Examples

DO160:NORM:VOLT:SURG

Query Syntax

none

DO160:NORMal:FREQuency:MODulation

This command will cause output frequency modulation. The level of modulation is the function of
the rate of modulation. Refer to Figure 8-5 in the User Manual. The command parameter is the
rate of modulation in Hz.

Command Syntax

DO160:NORMal:FREQuency:MODulation

Parameters

Examples

DO160:NORM:FREQ:MOD 0.1

Query Syntax

DO160:NORM:FREQ:MOD?

Returned Parameters

DO160:NORMal:FREQuency:TRANsient

This command applies to Group 1 only for the the Eurocae standard. Refer to Table 8-5 in the
User Manual.

Command Syntax

DO160:NORMal:FREQuency:TRANsient

Parameters

none

Examples

DO160:NORM:FREQ:TRAN

Query Syntax

none

Returned Parameters

none