AMETEK Lx Series II Programming Manual - Manual (Page 40)

Programming Manual Lx \ Ls Series II
36
4.2 Subsystem Commands
Subsystem commands are specific to AC source functions. They can be a single command or a
group of commands. The groups are comprised of commands that extend one or more levels
below the root. The description of common commands follows the description of the subsystem
commands.
The subsystem command groups are listed in alphabetical order and the commands within each
subsystem are grouped alphabetically under the subsystem. Commands followed by a question
mark (?) take only the query form. When commands take both the command and query form, this
is noted in the syntax descriptions.
You will find the subsystem command groups discussed on the following pages: