AMETEK Lx Series II Programming Manual - Manual (Page 232)

Programming Manual - Rev S Lx \ Ls Series II
228
Number Message String Cause Remedy
-254 "Media full" No storage space left
to save settings or
data. Delete other settings or data to make
room.
-255 “Directory full” Too many waveform
directory entries Delete one or more waveforms from
waveform memory to make room.
-256 “File name not found” Waveform requested
not in directory Check waveform directory for
waveform names present.
-257 “File name error” Incorrect filename Too many or non ASCII characters
used in waveform file definition.
-283 “Illegal variable name” Variable name illegal. Use ASCII characters only
-300 "Device specific error" Hardware related
error Check hardware for proper operation.
-311 "Memory error" Waveform memory
checksum error. May be the result of incomplete user-
defined waveform download. Check
interface and try downloading
waveform again. Successful
download may clear this error
condition.
Alternatively, use TRAC:DEL:ALL
command to clear waveform memory.
-314 "Save/recall memory
lost" User setup register
contents lost Store setup in same register again.
-315 "Configuration memory
lost" Hardware
configuration settings
lost. Contact AMETEK service department
at
[email protected]
to obtain instructions on restoring
configuration data.
-330 "Self-test failed" Internal error Contact AMETEK service department
at
[email protected]
-350 "Queue overflow" Message queue full. Too many message. Read status
using SYST:ERR query until 0, "No
Error" is received indicating queue
empty.
-400 "Query error" Unable to complete
query. Check programming manual for
correct query format and parameters
-410 "Query INTERRUPTED" Query issued but
response not read. Check application program for correct
flow. Response must be read after
each query to avoid this error.
-420 "Query
UNTERMINATED" Query incomplete. Check for terminator after query
command.
-430 "Query DEADLOCKED" Query cannot be
completed Check application program for
multiple queries
-440 "Query
UNTERMINATED" Query incomplete. Check for terminator after query
command.
0 "No error" No errors in queue
2 " Non-volatile RAM
CONFIG section
checksum failed" Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
3 " Non-volatile RAM CAL
section checksum failed" Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
4 " Non-volatile RAM
WAVEFORM section Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]