AMETEK Lx Series II Programming Manual - Manual (Page 173)

Programming Manual Lx \ Ls Series II
169
TO CALIBRATE OUTPUT:
-->CAL-|---|-|-|-(n)-->DLY-(n)-->STP-(n)-->VAL-(n)--->* [NOTE: NOT SUPPORTED ON Ls
Series ]
|AMP| |A| |
|B| |
|C| \------------------------------->*
TO CALIBRATE MEASUREMENT:
-->CAL-|VLT|-|-|-(n)---->*
|CUR| |A|
|PWR| |B|
|C|
TO REQUEST TALKING A PROGRAMMED PARAMETER OR MEASURED VALUE:
-->TLK-->|AMP|-|-|----->*
|FRQ| |A|
|CRL| |B|
|RNG| |C|
|PHZ|
|SNC|
|CLK|
|MNU| [NOTE: NOT SUPPORTED ON Ls Series ]
|ELT|
|VLT|
|CUR|
|PWR|
|APW|
|PWF|
|ALM|
|FLM|
|CFG|
|POF|
TO RECALL A REGISTER:
-->REC-(n)--->*
Figure 8-1: APE Command Tree
Notes:
* Represents either an IEEE-488 END or EOS message. The EOS message may be an ASCII
Carriage Return (CR), Line Feed (LF) or just LF.
n Represents a numeric value.