AMETEK Lx Series II Programming Manual - Manual (Page 126)

Programming Manual Lx \ Ls Series II
122
5.8 *RST
This command resets the AC source to the factory-defined states shown in Table 5-2 or to the
setup contained in setup register zero if the pon state is set to REG0. Which setting is recalled
depends on the state of the PONS setting. To change the selection, use the
OUTPut:PON[:STATe] command. To determine the present setting, use the query format.
Response is either RST or RCL0.
Item Value Item Value
CAL:STAT OFF [SOUR:]FUNC:MODE FIX
[SOUR:]FUNC:TRIG SIN
[SOUR:]FUNC:CSIN 100%
[SOUR:]LIST:COUN 1
[SOUR:]LIST:STEP AUTO
INIT:CONT OFF [SOUR:]PHAS ø1 = 0°,
ø2 = 240°,
ø3 = 120°
INST:COUP ALL [SOUR:]PHAS:TRIG ø1 = 0°,
ø2 = 240°,
ø3 = 120°
INST:NSEL 1 [SOUR:]PHAS:MODE FIX
OUTP OFF [SOUR:]PULS:COUN 1
OUTP:DFI OFF [SOUR:]PULS:DCYC 50%
OUTP:DFI:SOUR OFF [SOUR:]PULS:HOLD WIDT
OUTP:PROT:DEL 100ms [SOUR:]PULS:PER 1
OUTP:RI:MODE OFF [SOUR:]PULS:WIDT 0.01667s
OUTP:TTLT OFF [SOUR:]VOLT 1
OUTP:TTLT:SOUR BOT [SOUR:]VOLT:TRIG 1
SENS:SWE:OFFS:POIN 0 [SOUR:]VOLT:MODE FIX
SENS:SWE:TINT 10.42 µs or
31.25 µs [SOUR:]VOLT:PROT MAX
SENS:WIND Rectangular [SOUR:]VOLT:RANG MAX
[SOUR:]CURR Max
available [SOUR:]VOLT:SENS:SOUR INT
[SOUR:]CURR:PROT:STAT OFF [SOUR:]VOLT:SLEW INF
[SOUR:]FREQ 60Hz [SOUR:]VOLT:SLEW:MODE FIX
[SOUR:]FREQ:MODE FIX [SOUR:]VOLT:SLEW:TRIG INF
[SOUR:]FREQ:SLEW INF TRIG:DEL 0
[SOUR:]FREQ:SLEW:MODE FIX TRIG:SOUR BUS
[SOUR:]FREQ:SLEW:TRIG INF TRIG:SEQ2:SOUR IMM
[SOUR:]FREQ:TRIG 60Hz TRIG:SEQ2:PHAS 0
[SOUR:]FUNC SIN TRIG:SEQ3:SOUR BUS
Table 5-2 : factory-defined *RST states
Note *RST does not clear any of the status registers or the error queue, and does not affect any interface error
conditions. *RST does not affect the data in any of the lists. *RST sets the trigger system to the Idle state.
Command Syntax *RST
Parameters None
Related Commands *PSC *SAV OUTPut:PON[:STATe]