AMETEK Lx Series II Programming Manual - Manual (Page 220)

Programming Manual Lx \ Ls Series II
216
8.7.6 MS704 Power Fail State Commands
Power fail state tests can be started by sending one of the MS704:POW:FAIL commands.
Available power fail state commands are listed below.
MS704:POWer:FAIL[:COMBination][:ALL]
This command will run all power fail state combination operation mode tests.
Command Syntax MS704:POWer:FAIL[:COMBinaton][:ALL]
Parameters none
Examples MS704:POW:FAIL
Query Syntax none
MS704:POWer:FAIL[:COMBination]:ONE
This command will run the power fail state combination operation mode 1 test.
Command Syntax MS704:POWer:FAIL[:COMBinaton]:ONE
Parameters none
Examples MS704:POW:FAIL:ONE
Query Syntax none
MS704:POWer:FAIL[:COMBination]:TWO
This command will run the power fail state combination operation mode 2 test.
Command Syntax MS704:POWer:FAIL[:COMBinaton]:TWO
Parameters none
Examples MS704:POW:FAIL:TWO
Query Syntax none
MS704:POWer:FAIL:THRee
This command will run the power fail state combination operation mode 3 test.
Command Syntax MS704:POWer:FAIL:THRee
Parameters none
Examples MS704:POW:FAIL:THR
Query Syntax none
MS704:POWer:FAIL:PHASe:REVersal
This command will run the power fail state combination phase reversal test.
Command Syntax MS704:POWer:FAIL:PHASe:REVersal
Parameters none
Examples MS704:POW:FAIL:PHAS:REV
Query Syntax none
8.7.7 MS704 Transfer State Commands
Transfer state tests can be started by sending the MS704:TRAN command.
MS704:TRANsfer[:POWer][:INTerrupt]