AMETEK Lx Series II Programming Manual - Manual (Page 203)

Programming Manual Lx \ Ls Series II
199
MIL704:SSTate:WAVeform[:DISTortion]
This command will set the voltage distortion level for the steady state operation.
Command Syntax MIL704:SSTate:WAVeform[:DISTortion]
Parameters none
Examples MIL704:SST:WAV
Query Syntax none
MIL704:SSTate:FREQuency[:LEVel]
This command will set the frequency level for the steady state operation.
Command Syntax MIL704:SSTate:FREQuency[:LEVel]
Parameters none
Examples MIL704:SST:FREQ
Query Syntax none
MIL704:SSTate:FREQuency:MODulation
This command will set the frequency modulation for the steady state operation.
Command Syntax MIL704:SSTate:FREQuency:MODulation
Parameters none
Examples MIL704:SST:FREQ:MOD
Query Syntax none
8.6.4 MIL704 Transient Commands
MIL704:TRANsient:VOLTage[:LOW]
This command will set the low voltage level for the transient state operation.
Command Syntax MIL704:TRANseint:VOLTage[:LOW]
Parameters none
Examples MIL704:TRAN:VOLT
Query Syntax none
MIL704:TRANsient:VOLTage:HIGH
This command will set the high voltage level for the transient state operation.
Command Syntax MIL704:TRANseint:VOLTage:HIGH
Parameters none
Examples MIL704:TRAN:VOLT:HIGH
Query Syntax none