AMETEK Lx Series II Programming Manual - Manual (Page 213)

Programming Manual Lx \ Ls Series II
209
MS704:NORMal:VOLTage:PHASe:DIFFerence
This command will run the steady state voltage phase difference test. This test is only available in
the 3 phase mode.
Command Syntax MS704:NORMal:VOLTage:PHASe:DIFFerence
Parameters none
Examples MS704:NORM:VOLT:PHAS:DIFF
Query Syntax none
MS704:NORMal:VOLTage:MODulation
This command will run the steady state voltage modulation test.
Command Syntax MS704:NORMal:VOLTage:MODulation
Parameters none
Examples MS704:NORM:VOLT:MOD
Query Syntax none
MS704:NORMal:VOLTage:DISTortion:TOTal
This command will run the steady state voltage distortion test.
Command Syntax MS704:NORMal:VOLTage:DISTortion:TOTal
Parameters none
Examples MS704:NORM:VOLT:DIST:TOT
Query Syntax none
MS704:NORMal:VOLTage:TRANsient[:ALL]
This command will run all the steady state voltage transients tests.
Command Syntax MS704:NORMal:VOLTage:TRANsient[:ALL]
Parameters none
Examples MS704:NORM:VOLT:TRAN
Query Syntax none
MS704:NORMal:VOLTage:TRANsient:OVER
This command will run the steady state over voltage transients test.
Command Syntax MS704:NORMal:VOLTage:TRANsient:OVER
Parameters none
Examples MS704:NORM:VOLT:TRAN:OVER
Query Syntax none