Questionable instrument isummary status group – AMETEK Lx Series II Programming Manual User Manual
Page 158

Programming Manual
Lx \ Ls Series II
154
7.4
Questionable Instrument Isummary Status Group
Although only one group of Questionable Instrument Isummary Status registers is shown in Figure
7-1, there are actually three identical register groups. With the exception of bit 13, the register
structure is the same as the Questionable Status group. These three register groups monitor the
status signals of each individual phase of the three-phase AC source. To determine which phase
of the AC source is currently selected, use:
INSTrument:NSELect?
To set or read the status registers of another phase, first use:
INSTrument:NSELect
where
Register
Command
Description
Condition
STAT:QUES:INST:I
SUM:COND?
A register that holds real-time status of the circuits
being monitored. It is a read-only register.
PTR Filter
STAT:QUES:INST:I
SUM:PTR
A positive transition filter that functions as described
under STAT:QUES:INST:ISUM:NTR|PTR
commands in chapter 4. It is a read/write register.
NTR Filter
STAT:QUES:INST:I
SUM:NTR
A negative transition filter that functions as described
under STAT:QUES:INST:ISUM:NTR|PTR
commands in chapter 4. It is a read/write register.
Event
STAT:QUES:INST:I
SUM:EVEN?
A register that latches any condition that is passed
through the PTR or NTR filters. It is a read-only
register that is cleared when read.
Enable
STAT:QUES:INST:I
SUM:ENAB
A register that functions as a mask for enabling
specific bits from the Event register. It is a read/write
register.
Table 7-4: Questionable Instrument Isummary Status registers
The outputs of the Questionable Instrument Isummary Status group are logically-ORed into the
Isum bit (13) of the Questionable Condition register.