Look, Display, Status (previously shutter) – RED ONE OPERATION GUIDE User Manual

Page 98

Build 31 v31.6.16

NOVEMBER 28, 2011

LOOK
Look permits the look used by the camera on playback to be specified. Default is CLIP.
NOTE: When viewing clips recorded on cameras with Build 21 v21.1.0 or later firmware, the camera

will playback the clip using the LOOK and VIEW parameters used when the clip was recorded.

CAMERA: forces the camera to use current LOOK values to color process recorded RAW data files when

played back on-camera.
CLIP: Forces the camera to use recorded LOOK metadata values to color process recorded RAW data

files when played back on-camera.

DISPLAY
Display permits specific elements of the camera external monitor display to be disabled.
NOTE: Enabling/disabling these items effects selected item on all external monitor outputs. Disa-

bling the EVF Menu display also disables the EVF menu controls.

STATUS (PREVIOUSLY SHUTTER)
When checked, displays frame rate and sensor status on upper edge of all external monitors. Checked by

default.
Status also allows the user to choose if camera shutter value is reported in Degrees or 1/Seconds format.

The shutter display at the top of the RED LCD, RED EVF and all external monitors will change between

Degrees or 1/Seconds based on setting. Also, under SENSOR > SHUTTER >

SPEED

, values will also

change in relation to settings.
NOTE: Status values are always input in 1/seconds format, irrespective of this choice.

1. To change status preferences, push in or down on joystick to place checkmark in the STATUS check-

box.

2. FORMAT AS box will highlight.
3. Twist joystick to change the highlighted FORMAT AS box to the desired setting.
4. Move joystick right, up or push in to set.