RED ONE OPERATION GUIDE - Manual (Page 51)

Build 31 v31.6.16
© 2007-2011 RED.COM INC. NOVEMBER 28, 2011
50 50
STEP PRINT
Specifies the number of times each single frame captured in Time-lapse mode is to be recorded to the
digital media. Range is 1 to 10 frames. Default setting is 1 frames.
To adjust: Select STEP PRINT and
twist joystick to change the highlighted NUM FRAMES box to the desired setting (default is 1 frame.)
INTERVAL
Specifies the number of seconds the camera will wait before the next image is captured. Range is 1 to
1024 seconds. Default setting is 5 sec.
To adjust: Select INTERVAL and twist joystick to change the high-
lighted PERIOD box to the desired setting (default is 5 seconds.)
BURST TYPE
Burst type specifies the type of burst recording. To adjust: Select BURST TYPE and twist joystick to
change the highlighted FRAMES ARE box to REPEATED or UNIQUE. Default setting is REPEATED.
REPEATED: Specifies that each frame captured during the burst record be repeated. That is for each
Time-lapse event, a single frame is repeated N times, where N is the Step print value.
UNIQUE: Specifies that each frame captured during the burst record is unique. That is for each Time-
lapse event, N frames are captured and recorded, where N is the Step print value.
NOTE: When recording in Time-lapse mode, the RECORD tally lamp will remain illuminated.
Each successive event uses the next available Edge Code and Timecode value and uses the existing clip
name. This results in a complete Time-lapse sequence with a single clip name and correct timecode se-
quence. To exit Time-lapse mode, push the RECORD button.