Varispeed, Ramp, Frame rate – RED ONE OPERATION GUIDE User Manual

Page 47

Build 31 v31.6.16

NOVEMBER 28, 2011

VARISPEED

Before recording, enable this function by placing a checkmark in the

Varispeed checkbox. To select: Use

joystick to highlight VARISPEED checkbox. Push in or down on joystick to place checkmark in

VARISPEED checkbox.

RAMP

Enables a speed ramp; a transition over

Time from the Frame Rate to an End Rate.

1. To select and adjust, use joystick to highlight RAMP checkbox.
2. Push joystick in or down to place checkmark in RAMP checkbox.
NOTE: When RAMP is selected, VARASPEED checkbox will automatically be checked. If

VAIRSPEED is unchecked after, RAMP and VARISPEED will be unchecked. If RAMP is unchecked

after, VARISPEED will need to be unchecked separately.
3. TRIGGER box will highlight to allow you to choose between ON-RECORD and ON-EVENT.
4. Twist joystick to change the highlighted TRIGGER box to the desired setting.
5. Move joystick left or right to exit.

On-Record: On recording start, the capture frame rate will immediately start transitioning from the Frame

Rate to the End Rate.
On-Event: On recording start, the capture frame rate starts out at the Frame Rate, the start of the transi-

tion to the End Rate occurs only when an external GPI trigger has been received.

FRAME RATE

Enables the user to choose any single frame rate.

To adjust: Select FRAMERATE and twist joystick to

change the highlighted FRAMERATE box to the desired setting. Default value is 12fps.