First time use - setting up your red one, Master / slave camera configuration, First time use - setting up – RED ONE OPERATION GUIDE User Manual
Page 32: Your red one
Build 31 v31.6.16
NOVEMBER 28, 2011
© 2007-2011 RED.COM INC.
31
5. Leave the battery to charge for the appropriate time as shown in the table (assuming battery is com-
pletely discharged).
Charging RED-BRICK 140Wh using RED CHARGER
Charge Amount% (Minutes)
80 (120)
100 (210)
6. Unplug the battery when the LED becomes steady Green and/or all the LEDs illuminate on the battery
LED array.
FIRST TIME USE - SETTING UP YOUR RED ONE
Before recording, the camera must be set up properly.
1.
Physically set-up camera as desired.
2.
Download the latest camera firmware fro
and upgrade camera. Refer to
APPENDIX A: UPGRADING CAMERA FIRMWARE
3.
Perform a Black Shading Calibration. Refer to
under SYSTEM MENU CONTROLS.
4.
Verify Back Focus and adjust if necessary. Refer to
5.
Connect digital media to camera. Refer to
6.
Set up your project (Resolution, Time Base, Quality, etc.) Refer to
7.
APPENDIX B: MANAGING DIGITAL MEDIA
8.
Develop an exposure methodology using the camera tools (False Color, Histogram, etc.) and testing
to find the "fat RAW negative" for various light conditions. For detailed information refer to this link:
9.
Frame, focus and record.
MASTER / SLAVE CAMERA CONFIGURATION
For complete information on connecting and setting up cameras in a Master / Slave configuration, refer to
APPENDIX E: MASTER / SLAVE CAMERA CONFIGURATION