Rear of camera, Ab c d – RED ONE OPERATION GUIDE User Manual

Page 138

Build 31 v31.6.16

NOVEMBER 28, 2011

137

Selection between these two modes is made in SYSTEM > MONITOR >

. The default setting is

VIDEO (720p). In this mode, the HDMI output replicates the HD Preview video output.
The alternative mode is MENUS (DVI). In this mode, the HDMI output is compatible with most DVI based

SXGA or higher resolution computer monitors. Use is as an external Viewfinder.
NOTE: HDMI output is not active when PLAYBACK is set to 1080p.i.e. no output is available when

the RED-ONE camera is placed into playback.
NOTE: If an ANAMORPHIC record mode has been selected (2K ANA, 3K ANA, 4K ANA) the video
visible on the HDMI output has been stretched 2:1 to illustrate the final 2.40:1 aspect ratio of the

final image projection. The actual recorded image is 1.2:1 aspect.

REAR OF CAMERA

Camera DC Power Input

11.5 – 17V

Aux Power / GPIO A

e-SATA Interface (to RED-

DRIVE or RED-RAM digital

magazine)

Aux Power / GPIO B