Start – RED ONE OPERATION GUIDE User Manual

Page 104

Build 31 v31.6.16

NOVEMBER 28, 2011

103

NOTE: Prior to recording in Timelapse with extended exposure times (1/ 3 rd sec or longer) it is

recommended that a fresh Black Shading routine is performed. Ensure the camera is set up in

Timelapse at the desired exposure time, then perform a Black Shading calibration. After recording
Timelapse at extended exposure times, perform a Black Shading calibration again when you revert

to shorter exposure times (1/ 4 th sec or shorter) either in Timelapse, Normal or Varispeed modes.

START
1. Select BLACK SHADING, camera monitoring outputs will display:

2. Select START, camera monitoring outputs will display:

3. Select OK, camera monitoring outputs will display:

4. The camera records 100 frames of sensor data that is used to analyze the precise black level of each

pixel. This will take about 2 minutes. During this time, the camera will display (camera LCD will display

“Calibrating…”):

5. After analyzing sensor, the camera will display: