System, Update sw, Write log – RED ONE OPERATION GUIDE User Manual
Page 107
Build 31 v31.6.16
© 2007-2011 RED.COM INC.
NOVEMBER 28, 2011
106
106
SYSTEM
Allows all camera configuration parameters to be reset to the factory default values. When selected and
reset, the external monitors will display:
UPDATE SW
Update SW initiates a camera software (firmware) update.
For complete, detailed procedure, go to
APPENDIX A: UPDATING CAMERA FIRMWARE
WRITE LOG
Select to write camera’s .LOG file to the REDFLASH CF card, REDMAG, RED-DRIVE or RED-RAM maga-
zine. The .LOG file is a diagnostic tool that can assist RED with camera troubleshooting. After capture,
upload the .LOG file to the RED customer service team contactable at
After successfully writing log file to media, external monitors will display: