Seconds, Set clock, Remote – RED ONE OPERATION GUIDE User Manual
Page 110: Remote port, S4/i
Build 31 v31.6.16
NOVEMBER 28, 2011
© 2007-2011 RED.COM INC.
109
SECONDS
Allows the operator to enter new value for seconds. Range 0 – 59.
SET CLOCK
Set Clock loads the selected Date and Time parameters into the camera’s system memory.
NOTE: After pushing this key the camera will require re-boot as displayed. The new parameters will
take effect, and be visible as TIME CODE, on completion of the re-boot cycle.
REMOTE
Used to enable (and reset if necessary) the S4/i Lens Data Port. Controls include REMOTE PORT and
LENS PORT check box.
REMOTE PORT
Allows you to select between S4/I and AUX 232 (default is S4/i).
S4/i
Select S4/i to enable communication between the RED ONE and an S4/i compatible lens, and to enable
recording of the lens data as metadata in the RED ONE .R3D files. Refer to
located in PREFERENCES under SETUP in SYSTEM MENU SETTNGS.