Setting system clock, Set date, Year – RED ONE OPERATION GUIDE User Manual

Page 108

Build 31 v31.6.16

NOVEMBER 28, 2011

107

If external media is not attached to camera when attempting to perform a write log request, external moni-

tors will display:

SETTING SYSTEM CLOCK

Set Clock allows the camera’s real time clock to be adjusted. Select SET CLOCK and push joystick in or

down to display SET CLOCK menu.

NOTE: Current GMT date and time can be found using this web site or equivalent service:

http://wwp.greenwichmeantime.com/info/current-time.htm

If camera

Date

and

Time are set to GMT, and then set TIMEZONE to –8 for West Coast US (Pacific) time

etc. Or set

Date

and

Time

to local time, and set the TIMEZONE value to 0. To set TIMEZONE refer to

TIMEZONE

under TIMECODE in NEW PROJECT section under SYSTEM MENU CONTROLS.

SET DATE

1. To change date, push in or down on joystick to place checkmark in the desired checkbox.
2. Box on lower right will highlight.
3. Twist joystick to change the highlighted box to the desired setting.
4. Move Joystick up or push in to set.

YEAR
Allows the operator to enter a new value for the year between 2007 and 2020.