System menu controls, Sound, Rec enable – RED ONE OPERATION GUIDE User Manual

Page 73: Output level

Build 31 v31.6.16

NOVEMBER 28, 2011

SYSTEM MENU CONTROLS

This section describes the various controls available to configure the camera. These parameters are ac-

cessed from the SYSTEM menu key, located below and left of the RECORD button. Options available are

SOUND, MEDIA, PROJECT, MONITOR and SETUP.

SOUND

Sound menu provides output level adjustment, channel configuration and 48V management. Options

available are REC ENABLE, OUTPUT LEVEL and 48V MIC.

REC ENABLE

Push

REC ENABLE

to access the channel enable sub-menu.

Once enabled, the input type may be selected as either Line Level or Microphone Level. To help protect

against accidentally enabling +48V Phantom Power for Line Level input sources, or microphones that are

not capable of operating with 48V Phantom Power, 48V selection is provided in a separate sub menu ac-

cessed from the

48V ENABLE

key of the Sound Menu.

1. Push in or down on joystick to place checkmark in desired channel checkbox.
2. INPUT TYPE box will highlight to allow you to choose between LINE and MIC.
3. Twist joystick to change the highlighted INPUT TYPE box to the desired setting.
4. Move joystick left or right to select and exit.

OUTPUT LEVEL

The OUTPUT LEVEL parameter permits the line level audio monitor output provided from the 5-pin mini-

XLR connector to be trimmed to achieve a 0dBu / 0.775V RMS / - 20dBFS when receiving or an equiva-

lent 0dBu / 0.775V RMS / - 20dBFS reference level input.