RED ONE OPERATION GUIDE - Manual (Page 145)

Build 31 v31.6.16
© 2007-2011 RED.COM INC. NOVEMBER 28, 2011
144 144
CLIP NAMING CONVENTIONS
CAMERA POSITION / SLATE / CAMERA ID
Under SYSTEM MENU CONTROLS > SETUP > PROGRAM > POSITION , when Master is set to CENTER,
Master and Slave clips are both labeled "C", if Master is set to LEFT, Master clips are labeled "L" and
Slave clips are labeled "R", if Master is set to RIGHT, Master clips are labeled "R" and Slave clips are la-
beled "L".
Under SYSTEM MENU CONTROLS > PROJECT MENU > SLATE > CAMERA , when using Master / Slave
camera configuration, the Slave camera is forced to use the Master camera's ID, rather than using its
own.
NOTE: ****** are wildcard + day + date
If Master is LEFT and its camera I.D letter is B, the first clip recorded will be:
-
Master: B001_L001_******.RDC
-
Slave: B001_R001_******.RDC
If Master is RIGHT and its camera I.D letter is B, the first clip recorded will be:
-
Master: B001_R001_******.RDC
-
Slave: B001_L001_******.RDC
If Master is CENTER and its camera I.D letter is B, the Slave will also be CENTER and the first clip record-
ed will have the same file structure with the exception of the wildcards:
IMPORTANT: This position is NOT recommended when recording in Master / Slave configuration.
-
Master: B001_C001_******.RDC
-
Slave: B001_C001_******.RDC