RED ONE OPERATION GUIDE - Manual (Page 70)

Build 31 v31.6.16
NOVEMBER 28, 2011
© 2007-2011 RED.COM INC.
69
INTENSITY (PREVIOUSLY DARK DETAIL)
Intensity allows the intensity of the BOMB EVF to be adjusted. Range is -1.0 to 1.0. Default is 0.0.
OPEN GATE
Open Gate lets the camera preview images at 48Hz (50Hz) update rate when operating in 23.98 or 24.00
fps (25 fps) Project Frame Rates. In record, all monitor path images will be viewed at 48Hz, but recorded
at 23.98 or 24.00 fps (viewed at 50Hz, recorded at 25 fps)
NOTE: Use Open Gate with caution. Due to the doubling of sensor frame rate relative to capture
rate the following operational restrictions should be noted.
-
Open Gate is not available in Varispeed or Ramp modes.
-
Open Gate is not available for 50.00 or 59.94 Project Frame Rates.
-
Video Genlock may not be available when operating in Open Gate.
-
360-degree shutter is not available when operating in Open Gate.
NOTE: When deselecting Open Gate mode, it is normal to observe up to a 3 second disruption in
the RED EVF display.
AUDIO
Audio is recorded at 24-bit 48KHz, which provides high audio fidelity and wide dynamic range.
Line Level and Microphone Level analog audio input signals are routed via a high quality A/D and pre-
amplifier, whose gain stage may be controlled using the
Input Level control to achieve the desired audio
reference / recording level.
To assist with audio operating reference level setup, the camera provides a color-coded 3dB per division
Peak Level meter with 0dBu (-20dbFS) Witness Mark in the Graphical User Interface.
Peak Level meter range is –34dBu to +20dBu (-54dBFS to 0dBFS) and provides clip indication.
1. To adjust, select desired line and MICROPHONE/LINE. Default is LINE
2. INPUT LEVEL box will highlight to allow you to choose desired dB level.
3. Twist joystick to change the highlighted INPUT LEVEL box to the desired setting.