Appendix b: managing digital media, Pendix b: managing digital media – RED ONE OPERATION GUIDE User Manual

Page 118

Build 31 v31.6.16

NOVEMBER 28, 2011

117

14. If there is valid upgrade firmware (build) version on the SD/REDMAG/CF card or USB memory device,

all monitor outputs will display:

NOTE: If you choose to upgrade later, the camera will continue to operate on the current firmware

version.
NOTE: If the camera does not automatically display the upgrade, to manually upgrade the camera,

go to SYSTEM > SETUP > MAINTENANCE > UPDATE SW and the upgrade will be identified and the

upgrade message will be displayed. Refer to

UPDATE SW

in MAINTENANCE under SETUP in SYS-

TEM MENU CONTROLS.
15. Push joystick in or down to begin upgrade procedure. Camera LCD will display “Upgrading…” and all

monitor outputs will display:

16. After the upgrade completes (approx. 5 minutes), camera LCD will display “OK. Cycle Power” and all

monitor outputs will display:

17. Cycle the camera OFF and back ON to return to normal operation. During the camera power up pro-

cess, the camera will display the camera P.I.N and the upgraded firmware Build and Version number.

18. Perform a Black Shading Calibration. Refer to

under MAINTENANCE in SETUP un-

der SYSTEM MENU CONTROLS