RED ONE OPERATION GUIDE - Manual (Page 49)

Build 31 v31.6.16
© 2007-2011 RED.COM INC. NOVEMBER 28, 2011
48 48
REDCODE 42 REDFLASH 8GB REDFLASH 16GB RED-DRIVE
RED-RAM
REDMAG
2K 2:1 ---- 90 fps 100 fps 100 fps
2K 16:9 ---- 75 fps 90 fps 90 fps
2K ANA ---- 90 fps 100 fps 100 fps
3K 2:1 ---- 42 fps 48 fps 48 fps
3K 16:9 ---- 36 fps 42 fps 42 fps
3K ANA ---- 42 fps 48 fps 48 fps
4K 2:1 ---- 25 fps 25 fps 25 fps
4K HD ---- 25 fps 25 fps 25 fps
4K ANA ---- 25 fps 25 fps 25 fps
4.5K WS ---- 25 fps 25 fps 25 fps
TIME
When Ramp is enabled, this value specifies the transition time to be used by the camera between the
(start) Frame Rate and the End (frame) Rate.
To adjust: Select TIME and twist joystick to change the high-
lighted DURATION box to the desired setting. Range is 1-120 seconds. Default value is 5 sec.
END RATE
When Ramp is enabled, this value specifies the final (ending) speed of the ramp in frames per second.
When a ramp transition has been completed, the camera will continue to record at the End Rate until the
end of the Recording. Range is 1- 25 fps. Default value is 25 fps.
NOTE: When in Varispeed modes the camera maintains the last exposure time selected (unless the
requested frame rate requires a shorter exposure time) to provide a constant exposure. If a variable
exposure is required set the Shutter Mode to Relative - this is a fixed angle setting.
TIME-LAPSE
The Time-lapse menu supports single frame image capture and step frame recording under the control of
an internal Intervalometer, side RECORD key or an external (GPI) trigger.
NOTE: Prior to recording in Timelapse with extended exposure times (1/ 3 rd sec or longer) it is
recommended that a fresh Black Shading routine is performed. Ensure the camera is set up in
Timelapse at the desired exposure time, then press SYSTEM > SETUP > MAINTENANCE > BLACK
SHADING to perform a Black Shading calibration. After recording Timelapse at extended exposure