Recall, Slate, Camera – RED ONE OPERATION GUIDE User Manual

Page 79

Build 31 v31.6.16

NOVEMBER 28, 2011

When the project settings are saved successfully to the SD card, the following message will be displayed:

RECALL
When selected, the operator will be able to load the desired saved project settings. If not project settings

have been saved, “None Available” will be displayed as a selection. If project setting are available on the

SD card, they will be displayed as selections.

SLATE

Slate lets the operator identify the specific camera used for the project. Combined with reel numbers and

clip numbers assigned by the camera, all clips recorded on the digital media may be uniquely identified,

simplifying post-production and media archiving workflows.

CAMERA
SET CAMERA ID is a single letter (A-Z) that provides a unique identifier for the camera in a multi-camera

production environment.

When you push record, the camera names the clip being recorded on the digital media.
E.g. A001_C001_0515A6.RDC
Where: A = camera A, 001 = reel 001, C001 = clip 001, and 0515 = May 15 and A6 is a two digit alphanu-

meric random number generated by the camera. This number helps avoid duplicate file names if two

cameras are inadvertently named A on the same project.
1. To set camera ID, select CAMERA and press in or down on joystick.
2. Twist joystick to change the highlighted SET CAMERA ID box reel letter between A and Z (default is

A).