Metrohm tiamo 2.3 Manual - Manual (Page 914)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
898 ￭￭￭￭￭￭￭￭ tiamo 2.3
-
negative measured value alteration
auto
The titration direction is determined automatically from the start meas-
ured value and the set endpoint.
Temperature
Manually entered titration temperature. If a temperature sensor is connec-
ted and the Temperature measurement is set on the General/Hard-
ware tab under Sensor to automatic or continuous, then the temper-
ature will be measured continuously. This value is used for temperature
correction in pH measurements.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value 25.0 °C
Measuring point recording
Time interval measuring point
Time interval for entering a measuring point in the measuring point list.
Titrando, 855
Range
0.1 ... 999999 s
Default value 2.0 s
Titrino
Range
1 ... 999999 s
Default value 2 s
Start time
The measuring points are not entered in the measuring point list until this
time has elapsed since the start of the titration.
Range 0 ... 999999 s
Default value 0 s
Start measured value
The measured values are not entered in the measuring point list until this
value has been reached.
Titrando, 855
Range
-2000.0 ... 2000.0 mV