Metrohm tiamo 2.3 Manual - Manual (Page 687)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 671
Command variables
The following command variables are generated in the method run by the
command MET Cond and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BP{x}.DME Measured value differential for the break point ×
(1…9)
.BP{x}.MEA Measured value for the break point × (1…9) in the
unit of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BP{x}.VOL Volume for the break point × (1…9) in mL
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0
= READY; invalid (variable not available) = Com-
mand has never been started
.CLC Cell constant of the sensor used in the command
for conductivity measurement cells
.CONC Concentration of the solution used for the com-
mand
.CYL Cylinder volume of the exchange or dosing unit
used for the command
.DBL Total duration for the processing of the command
in s
.DSC Time for processing all start conditions in s
.EME End measured value (measured value after process-
ing of the command) in the unit of the measured
value
.EP{x}.DME Measured value differential for the endpoint × (1…
9)
.EP{x}.MEA Measured value for the endpoint × (1…9) in the
unit of the measured value
.EP{x}.MEP Quantity of endpoints in the window × (1…9); 1 =
1 endpoint, 2 = 2 or more endpoints, 3 = EP
corrected with Autodrift, 4 = EP corrected
with manual drift
.EP{x}.TEM Temperature for the endpoint × (1…9) in °C