Metrohm tiamo 2.3 Manual - Manual (Page 1597)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual control
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1581
Titer
Display of the titer of the attached solution. This field only appears for
intelligent exchange/dosing units or if the solution for non-intelligent
exchange/dosing units has been selected.
8.4.1.3 Dosing - Preparing
Program part: Manual control
Here the preparing of exchange/dosing units can be started and stopped.
This tab appears when selecting a single dosing device as well as with all
dosing devices.
Note
This tab is not displayed for an internal dosing device on the Titrinos
702, 716, 718, 719, 720, 721, 784, 785, 794, 795, 798.
[Start]
Start preparing for the selected dosing device(s). The parameters defined
for the exchange unit or dosing unit will be used.
[Stop]
Stop preparing for the selected dosing device(s).
8.4.1.4 Dosing - Filling
Program part: Manual control
Here the filling of exchange/dosing units can be started and stopped. This
tab appears when selecting a single dosing device as well as with all dos-
ing devices.
Note
Before filling the dosing devices connected to Titrinos, ensure that the
corresponding exchange or dosing units are attached. If the filling pro-
cedure is started nevertheless, the Titrino might not be actuated any-
more and has to be switched off and on again.
[Start]
Start filling for the selected dosing device(s).
[Stop]
Stop filling for the selected dosing device(s).