Metrohm tiamo 2.3 Manual - Manual (Page 398)

4.8 Subwindow Curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
382 ￭￭￭￭￭￭￭￭ tiamo 2.3
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Quantity
Selection of the quantity to be shown on the x axis.
For DET commands
Selection
Volume [mL] | Measured value | ERC | Time [s] |
Temperature [°C] | Calculated 1...3 | External
1...3
Default value Volume [mL]
For MET commands
Selection
Volume [mL] | Measured value | dMW | Time
[s] | Temperature [°C] | Calculated 1...3 | Exter-
nal 1...3
Default value Volume [mL]
For SET, STAT, DOS and KFT commands
Selection
Time [s] | Measured value | Volume [mL] | dV/
dt [µL/min] | Temperature [°C] | Calculated
1...3 | External 1...3
Default value Time [s]
For KFC commands
Selection
Time [s] | Measured value | Amount [µg] |
Charge [mAs] | Drift [µg/min] | dV/dt [µ/min] |
Ugen | Igen [mA] | Calculated 1...3 | External
1...3
Default value Time [s]
For BRC commands
Selection
Time [s] | Measured value | Amount [µg] |
Charge [mAs] | Drift [µg/min] | dV/dt [µ/min] |
Ugen | Igen [mA] | Calculated 1...3 | External
1...3
Default value Time [s]