Metrohm tiamo 2.3 Manual - Manual (Page 1125)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1109
Identifica-
tion Description
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.STY Type of stop with which the command was stopped: 1
= normal;0 = manual or after error
5.6.5.7.2 CAL MEAS Conc - General/Hardware
Tab: Method ▶ CAL MEAS Conc ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the sensor and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.