Metrohm tiamo 2.3 Manual - Manual (Page 1239)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1223
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | 814 USB Sample Processor
Default value 814 USB Sample Processor
Rack test
on | off (Default value: off)
If this option is enabled, the rack attached will be checked to see that it is
the correct one.
Test rack
Selection of the rack name for the rack which must be put on. In this way
you can ensure that the method can only be carried out with this rack. If
another sample rack is detected while executing the command, a message
is displayed and an exit track will be started if there is one defined.
Selection all sample racks listed in the configuration
5.6.7.8 HEATER
5.6.7.8.1 HEATER - Overview
Dialog window: Method ▶ HEATER ▶ Properties... ▶ HEATER - 'Command name'
Command for controlling the oven temperature.
Instruments
This command can be executed with the following devices:
Sample changer: 774 and 874
Photometer: 089
Appearance
The command has the following appearance: