Metrohm tiamo 2.3 Manual - Manual (Page 1616)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1600 ￭￭￭￭￭￭￭￭ tiamo 2.3
8.4.5.2 Measure - Measure
Program part: Manual control
Here the measurement can be started and stopped.
Measured quantity
The selectable measured quantities depend on the device whose measure-
ment input has been selected in the device selection.
Selection pH | U | Ipol | Upol | Temperature | Conc | Cond
Note
Which other parameters are displayed depends on the selected meas-
ured quantity.
Sensor
Selection of the sensor, the ones of the sensor table are available.
Depending on the measured quantity only specific sensor types can be
selected.
Note
If an intelligent sensor is connected to the measurement input, then it
will be displayed.
Measure temperature
Temperature, which can be entered manually. If a temperature sensor is
connected, the temperature is measured continuously and the value
entered will be ignored. The value is used for the temperature correction
of the measurement.
Titrando, 855
Range
–20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
–170.0 ... 500.0 °C
Default value 25.0 °C
I(pol)
The polarization voltage is the voltage applied to the polarizable electrode
during a amperometric measurement.