Metrohm tiamo 2.3 Manual - Manual (Page 603)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 587
Initial volume
Volume which must be present in the measuring vessel before the com-
mand is started.
Range 0.01 ... 9999.99 mL
Default value 50.0 mL
Lower limit pH
Value for the lower limit of the Gran evaluation range.
Range -20.000 ... 20.000
Default value -20.000
Upper limit pH
Value for the upper limit of the Gran evaluation range.
Range -20.000 ... 20.000
Default value 20.000
5.6.3.3.2.8 MET pH - Additional measured values
Tab: Method ▶ MET pH ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings:
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 927).