Metrohm tiamo 2.3 Manual - Manual (Page 54)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
38 ￭￭￭￭￭￭￭￭ tiamo 2.3
Designation Description Commands
.CAL Status of the calibration: 1 = cali-
brated normally, 0 = canceled,
because reference wavelength
was not found. CAL Spec
.CBY Command status; 1 = Condition-
ing activated, 0 = Condition-
ing deactivated SET, KFT, KFC,
BRC
.CLC Cell constant of the sensor used in
the command (with conductivity
sensors) MET Cond, MEAS
Cond, CAL Cond
.COD Coefficient of determination (r 2 ),
calculated from calibration func-
tion and confidence interval.
CAL LOOP Opt
.COK Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not fulfil-
led SET, KFT, KFC,
BRC
.CONC Concentration of the solution
used for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CP{#}.MEA Measured wavelength of the cali-
bration point in nm. If no meas-
ured peak can be assigned, then
not found will be entered. CAL Spec
.CP{#}.REF Reference wavelength of the cali-
bration point in nm. CAL Spec
.CYL Cylinder volume of the exchange
or dosing unit used for the com-
mand DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY